1.Print our Ring Sizer PDF on standard 8.5" x 11" paper at 100% scale (ensure scaling is turned off).

2.Measure the gray section, it should be 3.5 inches from end to end.

3.If you have a ring that fits you well (or if you have a ring that you know fits the person you are gifting to), then place the ring on top of each sizing circle until you find the match. The matching circle should fit perfectly inside the ring.

4.Alternatively, cut out the sizing tool (the top section that looks like a ruler), and wrap the piece of paper around the desired finger. The number that aligns closest with the "Read Size Here" line will be your size.

5.If you are in between two sizes, it is always best to round up rather than down.

1.Cut a thin strip of paper, about 10-12cm long.

2.Wrap the strip of paper tightly around your desired finger.

3.Using a pen or pencil, mark the point where the paper overlaps itself.

4.Lay the strip of paper on a flat surface and use a ruler to measure the distance from the end of the strip to the marking you made, in millimeters. This will give you a measurement of the circumference of your finger.

5.Using the below chart, convert your measurement into a standard US ring size.

6.If you are in between two sizes, it is always best to round up rather than down.

Please refer to the following size chart